ACT-2 tester is used to check the correct operation of the following types of A/C compressors:
– Compressor with electromagnetic clutch – check the condition of the electromagnetic clutch,
– Compressor with clutchless drive – check the operation of the solenoid valve that controls the compressor output.
Attention! The tester does not support solenoid valves with a built-in safety diode (valves used in Mercedes cars, among others). Using a tester for this type of valve may damage the valve or the tester.
The tester can be used both on the air conditioning test bench and by checking the compressor in the car.
Technical parameters of the tester:
| Supply voltage | constant, range 12 … 15V |
| Current consumption | 70 mA (current drawn by the tester without load) |
| Control signal generator | |
| Frequency range | 20Hz – 1000Hz |
| Frequency control accuracy | 1Hz |
| Amplitude of the output signal | From 0V to the supply voltage |
| Type of control | Ground controlled output and supply voltage controlled output |
| Coefficient adjustment range | 0% … 100% |
| Coefficient adjustment accuracy | 0.1% |
| Measurement of the control signal | |
| Measured frequency range | 20Hz – 1000Hz |
| Input signal amplitude | from 0V to supply voltage |
| Switching voltage threshold | 2.5V |
| Security | |
| Voltage | Exceeding the supply voltage (above 18V) |
| Current | Exceeding the allowable current of 6.3A (fuse) and short circuit protection |
ACT-2 kit contents:
ACT-2 device
Measurement and control cable (15pin plug)
6A spare fuse
15V power supply
You can download the manual for the device by clicking HERE
